A new set's track has set around in the box, unsealed and the air gets to it and it gets a layer of oxidation on the surface. That means when you put your brand new train on your brand new track it may not run properly, it may even stop. It may not get enough power to start from a dead stop on the whole track because the rail joiners and areas they touch, may also have a microscopic amount of corrosion. I have verified all the couplers function properly. Automatically couple when u back the train up slowly to each car.
I HAVE TAKEN ALL THE TRACK SECTIONS AND TAKEN THE ELECTRICAL RAIL JOINTERS OFF, SOAKED THEM IN SPECIAL CHEMICALS TO MAKE THEM CLEAN AS NEW AND LUBRICATED THEM WITH SPECIAL CHEMICALS SO THEY WILL MAKE A BETTER AND LONGER LASTING CONTACT THEN NEW ONES. THE FEW CONNECTORS THAT DID NOT LOOK GOOD, OR TEST GOOD, I REPLACED WITH NEW ONES. I HAVE ASSEMBLED THIS WHOLE 14 PIECE TRACK AND CLEANED IT WITH THE TECHNIQUES FOUND ON MANY PROFESSIONAL TRAIN OPERATORS'S VIDEOS BY. 1 Sanding the whole track WITH VERY FINE SANDPAPER (400, then 600 grit) to remove any oxidation present.
I will include the 400 and 600 grit blocks for u to clean the tracks again in the future. (THE WASHER BLOCK, CAN OF CLEANER AND THE RAG SHOWN ARE NOT INCLUDED). 2 Rubbed the whole track with a stainless steel washer to heal any of the scratches that were created in step one. 3 Cleaned all of the debris off of the track using a chemical that cleans and protects the metal. 4 cleaned and protected the railroad ties best way to adhere ur track to the layout is with household caulking - do not use nails, u will most likely mess up the track, and break the ties.Wipe the bottom of the track off with isopropyl alcohol or equivalent before glueing down to remove my protective chemicals. 4 Ran the train a few laps around the track to verify that it can be stopped and started on each of the 14 segments, and that it runs smoothly and does not have hesitations. I have also given special attention to the locomotive. 1 Lubricated all wheel axles on the locomotive and. 2 cleaned all the eight wheels on the locomotive. 3 Verified it ran smoothly on the whole track with a dozen start/stops. 4 Verified the headlight works.
5 Cleaned any "shelf dust" off and waxed it. 6 Cleaned the 4 contacts that receive power from the wheels.
I have also cleaned all 4 cars. I have also Tested the original throttle controller. I have hooked up the red cable to run the whole train for testing. 36 Oval (has 2 straight tracks). 11 pieces of curved track.
1 piece of curved track with cord connector. 2 pieces of straight track. Bag of telephone poles (unopened). Power pack and speed controller with red cable to track.
Copy of the instructions included. This set has the standard Couplers.
This item is in the category "Toys & Hobbies\Model Railroads & Trains\Railroads & Trains\Starter Sets & Packs". The seller is "johndeerebill1" and is located in this country: US. This item can be shipped to United States.